if you mean you want the pillars reaching 6 ft from the ground, you could use rc fenceposts, sunk into the ground and tight to the wall. if you want them to blend in you can use dark brown masonry paint to match the fence stain on the wood, or if you can be bothered you can build bricks round them.
because your wall and caps are concrete filled and because of your property line situation it may be okay to attach the fence posts there. people have had success doing this, however; more often than not, the fences and caps have failed. if you decide to proceed with this method,
if it was me i would concrete in your posts about 1 inch away from the wall then attached a piece of 2-3'' timber at the top where your 3ft panel will go and then your panel to that. this will project the panel out over the wall to create a nice flush-ish front. it will look a little weird from the back though.
not using posts fixing directly to the wall, as it says at the top ^^^^ yes, thats the problem the footings of the wall will be leverage by the extra fencing, and break, and the panels will have little support anyhow, and break must use posts, set into ground at intervals, and go from there
how should a fence be attached to a timber wall a fence . fence painting and staining guide: quick tips hgtvyour fence is an important part of your home. it provides security, privacy, andwith proper carea great deal of curb appeal. once you have invested in a fence, routine maintenance can keep it strong and looking good for years. by
odds are, there is no footer to the knee wall, it might just be a gravel pad. if you put a 6' fence on top of that, any wind that hits it will put a heck of a lot of torque on the block and probably knock it over. maybe not right away, but you'll notice cracks in the mortar then, the wall will start leaning.
1. treat the wood. first things first, before you start screwing any wood to walls or fences, you need to treat the wood. if you dont, your trellis will rot and all your hard work will go to waste. so grab a pot of our fence treatment or wood preserver and coat your trellis. this will protect the wood from all weather and can last for years. 2.
i'm running a wood panel fence up to the corner of my house. question: is there any reason not to attach a fence post to the house itself? i've seen people around here do it both ways - sink a post next to the house, and just bolt the post to the house itself. the wall was stucco, so there's minimal chance of rot
wooden slatted fencing, to be attached on top of a garden wall ebay september 2019 find many great new and used options and get the best deals for wooden slatted fencing, to be attached on top of a garden wall at the best online prices at ebay
you will need to take a bolt and attached the fence panel to the post and screw together. depending on the size of the fence, you will need to consider if you will need a large bolt or a small
if safety and security are the reason for the fence, this method should strongly be considered. the depth of the hole should be as deep as possible but at least 4 inches. grout not concrete should be used to install posts on top of a wall. a core drill can be rented at your local tool rental store.
fence panels are usually made from a weather-resistant wood species like redwood or cedar, but they still need protection from sun and rain if you want them to last. painting the posts and panels with a protective stain before you mount the panels allows you to spread a protective coat on the edges of the panels that abut the posts.
if it's a matter of the fence no longer being stable, you are responsible for your fence and if you can't stabilize it from your side of the property, you have a choice to ask your neighbor if it